pasobcp.blogg.se - Nexus 7000 configuration guide

#NEXUS 7000 CONFIGURATION GUIDE HOW TO#

By default, this parameter is enabled.įor information on configuring the MDIX parameter, see the “Configuring the MDIX Parameter” section. This parameter applies only to copper interfaces. The medium dependent interface crossover (MDIX) parameter enables or disables the detection of a crossover connection between devices. To identify the physical port for an interface, you can activate the beacon parameter for the interface.įor information on configuring the beacon parameter, see the “Configuring the Beacon Mode” section. The beacon mode allows you to identify a physical port by flashing its link state LED with a green light. For information on configuring this parameter for other interfaces, see the “Configuring the Description” section. Using a unique name for each interface allows you to quickly identify the interface when you are looking at a listing of multiple interfaces.įor information on setting the description parameter for port-channel interfaces, see the “Configuring a Port-Channel Description” section. This section includes the following topics:įor the Ethernet and management interfaces, you can configure the description parameter to provide a recognizable name for the interface. Information About the Basic Interface Parameters Note To configure the parameters that are specifically used for Layer 2 interfaces (access or trunking interfaces), see Chapter3, “Configuring Layer 2 Interfaces” To configure parameters that are specifically used for Layer 3 interfaces (routed interfaces, subinterfaces, VLAN interfaces, loopback interfaces, and IP tunnels), see Chapter4, “Configuring Layer 3 Interfaces” This chapter includes the following sections:

#NEXUS 7000 CONFIGURATION GUIDE HOW TO#

This chapter describes how to configure the basic interface parameters on Cisco NX-OS devices.

Feature History for Configuring Basic Interface Parameters.

Verifying the Basic Interface Parameters.

Configuring Rate Limits for Packets that Reach the Supervisor.

Removing a Port Profile from a Range of Interfaces.

Assigning a Port Profile to a Range of Interfaces.

Entering Port-Profile Configuration Mode and Modifying a Port Profile.

Shutting Down and Activating the Interface.

Configuring the Interface Speed and Duplex Mode.

Configuring the Error-Disabled Recovery Interval.

Sharing the Bandwidth Among a Port Group.

Configuring the Basic Interface Parameters.

Time Domain Reflectometry Cable Diagnostics.UDLD Aggressive and Nonaggressive Modes.Unidirectional Link Detection Parameter.Information About the Basic Interface Parameters.